R.M. Technologies

 

 

 

 

 

Solid-State NH3 Ammonia Sensor / Transmitter

 

Model SS-M-NH3-N/1 (Master/Slave)

 

bullet

This sensor uses a porous metal oxide with catalyst that is heated by a small internal heater.

bullet

The sensor exhibits a large decrease in resistance when exposed to NH3 gas, and gives a 4/20-mA output, non-linear.

 

Characteristics

 

bullet

This sensor has a long life, five to ten years.

bullet

The sensor life is shortened three to four months, if exposed continuously to interference gas. 

bullet

The sensor will normally become more sensitive as it ages.

bullet

The sensor has broad-spectrum characteristics, i.e., it will sense other gases, such as methane, products of combustion, propane, butane, ethylene, chlorine, hydrogen, carbon monoxide, some refrigerants, paint vapors, solvents etc...

bullet

It is best used for trip levels in the 150/300 PPM range, up to 1% (10,000 PPM), due to its sensitivity to other gases.

bullet

It requires modification if used in temperatures of -15 F or below.

bullet

Keep the sensor away from high moisture changes, i.e., defrost vapor and high air movement.

bullet

It should be checked with certified calibration gas at least once every six months.

 

Applications

 

bullet

This sensor is ideal for machine rooms with outside fresh air make-up where no other gases are present, i.e., carbon monoxide from cars or trucks.

bullet

It is good for isolated vessel rooms.

bullet

It is ideal for most attic spaces.

bullet

It is good for refrigerated rooms in which the floors are not washed with alcohol-based cleaners and where products are stored that do not give off gases.

bullet

DO NOT apply where smoked meats, bananas and other fruits or vegetables are stored.

bullet

Gas-driven lifts cannot be used around solid-state sensors.

bullet

It is NOT good for low PPM set points, below 150 PPM, wash down areas, food processing rooms, rooms where cleaning solvents are used, etc.

 

 

    Contact Information

Head Quarter

 

Telephone:           856-914-1860 & 856-914-1861

 

Fax:                      856-914-9292

 

Postal address:     R.M. Technologies Inc.

                              4437 Church Rd.

                              Mt. Laurel, NJ 08054

 

Branch Location

 

Telephone/Fax:    239-642-7662

 

Postal address:     R.M. Technologies Inc.

                              950 N. Collier Blvd.

                              Suite 423

                              Marco Island, FL 34145

 

Electronic mail:   techsvs@rmtech.net

                             

                             custsvs@rmtech.net

                             

 

 

 

Copyright [2003] [R.M. Technologies Inc.]